Wow, you sound desperate! I hope this tells you something mate.
The following is from a GSR 12012, running 12.0(10)S1
_______________________________________________________________
router#sho int ser 1/0
Serial1/0 is up, line protocol is up
Hardware is Packet over DS3
Description: ____________
Internet address is x.x.x.x /30
MTU 4470 bytes, BW 44210 Kbit, DLY 200 usec, rely 255/255, load 1/255
Encapsulation HDLC, crc 16, loopback not set
Keepalive set (10 sec)
Last input 00:00:07, output 00:00:02, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 6000 bits/sec, 20 packets/sec
5 minute output rate 6000 bits/sec, 12 packets/sec
43343044 packets input, 417655339 bytes, 0 no buffer
Received 0 broadcasts, 267 runts, 0 giants, 0 throttles
0 parity
777 input errors, 57 CRC, 242 frame, 0 overrun, 0 ignored, 211 abort
42328073 packets output, 594197015 bytes, 0 underruns
0 output errors, 0 applique, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
1 carrier transitions
router#sho controllers serial 1/0
Interface Serial1/0 (DS3 port 0)
hwidb = 0x61614360
ssb = xxxxxxxx, ds = xxxxxxxxx
Line state is up
rxLOS inactive, rxLOF inactive, rxAIS inactive
txAIS inactive, rxRAI inactive, txRAI inactive
Current configurable parameter settings:
Loopback is none, Framing is c-bit
Clock source is line, Cable length is 50
DSU mode is cisco, DSU bandwidth limit is 44210
Payload scrambling is disabled, CRC is 16
Bert pattern is disabled, Bert interval is 0
Transmitter delay is 0, Encapsulation is HDLC
Idle character is flags, Invert data is disabled
Remote fullrate has no request outstanding
Remote accept is enabled, MTU is 4470
MIB information:
Data in current interval (517 seconds elapsed):
0 Line Code Violations, 0 P-bit Coding Violations
0 C-bit Coding Violations
0 P-bit Err Secs, 0 P-bit Sev Err Secs
0 Sev Err Framing Secs, 0 Unavailable Secs
0 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Sev Err Secs
No alarms detected.
-----Original Message-----
From: ?????
To: cisco group study
Sent: 1/30/2001 5:40 PM
Subject: gsr12012 show command..
in the gsr12012, what show command will give us a information of
specific line.. etc.. oc3 or oc12..
show line ? or show port ? or show interface ?
plz, let me know about it...
if possible, could you give me some dump of that show command?
it's so urgent..
plz..
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]