A couple of weeks ago I was looking for an alternative to 'show dialer' to
display the value of the idle timer in IOS 12.1 on an AS5300.
I found an answer. For those who are interested, 'show int' now shows the
information (at least on an AS5300). It is also much easier to determine
which interface is bound to what.
JMcL
router1#sh int
Dialer7 is up, line protocol is up
Hardware is Unknown
Interface is unnumbered. Using address of Loopback0 (x.x.x.x)
MTU 1500 bytes, BW 512 Kbit, DLY 20000 usec,
reliability 255/255, txload 198/255, rxload 142/255
Encapsulation PPP, loopback not set
Time to interface disconnect: idle 00:01:59 <-- Idle timer :-)
Interface is bound to Se0:23
Interface is bound to Se0:24
Interface is bound to Se0:25
Interface is bound to Se0:26
Interface is bound to Se0:27
Interface is bound to Se0:28
Interface is bound to Se0:29
Interface is bound to Se0:30
LCP Open, multilink Open
Open: IPCP, CDPCP, IPXCP
Last input 00:00:00, output never, output hang never
Last clearing of "show interface" counters 1w2d
[stats snipped]
Bound to:
Serial0:23 is up, line protocol is up
[all the usual guff snipped]
Timeslot(s) Used:24, Transmitter delay is 0 flags
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
