I used PPTP for a VPN I just set up, but I was using a PIX, not a router.
You'll probably need to get a higher level of IOS, one with encryption,
which will allow you to do the vpdn commands for PPTP.
I would suggest going to the below link to get an intro to the vpdn commands
for PPTP setup:
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_v53/config/adv
anced.htm#xtocid579420
I found it relatively easy to set up, considering this was my first time
configuring a VPN. Also, I did get this to work with NAT, but according to
CCO, it will not work with PAT.
Good luck.
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, February 14, 2001 3:48 PM
To: [EMAIL PROTECTED]
Subject: NAT/PAT port pass-through
Hi all,
Im just experimenting with NAT/PAT and want to try to tunnel back to an
internal NT server to establish a VPN with it. Say the internal address is
10.1.1.100 I want to pass all traffic from the external IP w.x.y.z(i s0) to
internal 10.1.1.100(int e0) for the following ports
Protocol ID TCP, Port 1723
Protocol ID 47, port all
Can anyone help out with some config pointers?
I've got NAT/PAT set up and working.
I would like to use PPTP to the router and let the router establish the VPN
but I don't think this router will support it. It is running
11.1(c1600-y-l.113-2)
Any thoughts?
Craig Lindstrom
eSage
http://www.eSage.com
(801) 796-9595
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
