Colleagues,
I've been browsing cisco.com for some info on inter-vlan routing with the
2610. Cisco says there is a way to build ethernet sub-interfaces for
trunking to a switch. But when I do a "int e0/0.100" and try to add an IP
address, it gives me an error message:
"Configuring IP routing on a LAN subinterface is only allowed if that
subinterface is already configured as part of an IEEE 802.10 or ISL vLAN."
There doesn't seem to be an "encapsulation [dot1q | isl] command on this
router, and mls obviously isn't supported.
I know that I could just give this interface multiple IP address and use a
"switchport access multi" command on the switch-- but that would be too
easy.
By the way, I am trying to do this with a 2924XL. Should this or shouldn't
this work?
Many thanks in advance,
Best Regards,
Scott M. Trieste
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
