Scott,
2610 doesn't have FastEthernet interface. You can configure ISL
or 802.1q trunking only on FE.
Sasa
"Scott M. Trieste" wrote:
>
> Colleagues,
>
> I've been browsing cisco.com for some info on inter-vlan routing with the
> 2610. Cisco says there is a way to build ethernet sub-interfaces for
> trunking to a switch. But when I do a "int e0/0.100" and try to add an IP
> address, it gives me an error message:
> "Configuring IP routing on a LAN subinterface is only allowed if that
> subinterface is already configured as part of an IEEE 802.10 or ISL vLAN."
>
> There doesn't seem to be an "encapsulation [dot1q | isl] command on this
> router, and mls obviously isn't supported.
>
> I know that I could just give this interface multiple IP address and use a
> "switchport access multi" command on the switch-- but that would be too
> easy.
>
> By the way, I am trying to do this with a 2924XL. Should this or shouldn't
> this work?
>
> Many thanks in advance,
>
> Best Regards,
>
> Scott M. Trieste
>
> _________________________________
> FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
