Make sure the cable you are using a cable with the DCE end plugged in to the serial port. You cannot set the clock rate if the cable has the DTE end plugged in to the Serial port. Use the command: show controllers Louie -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of mtxpert Sent: Tuesday, March 20, 2001 5:39 PM To: [EMAIL PROTECTED] Subject: Help with frame-relay switch configuration I have a Cisco 4000 I just received and I can't get it to take clock on 2 interfaces at once. Here's a copy of the config after I just typed "lock rate 56000" at the config-if mode for serial 0. Current configuration: ! version 11.1 service udp-small-servers service tcp-small-servers ! hostname R4000 ! enable secret 5 $1$1ETI$xqeVrzT8qlamhBz1pI4ZA/ ! frame-relay switching ! interface Serial0 no ip address encapsulation frame-relay frame-relay intf-type dce frame-relay route 301 interface Serial1 101 ! interface Serial1 no ip address encapsulation frame-relay clockrate 56000 frame-relay intf-type dce frame-relay route 101 interface Serial3 301 ! interface Serial2 no ip address shutdown ! interface Serial3 no ip address encapsulation frame-relay frame-relay intf-type dce ! no ip classless ! ! line con 0 password cisco login line aux 0 modem InOut line vty 0 4 password cisco login ! end Without applying clock the router won't allow the dlci's to map. This is my first attempt with a 4000 router. Here's the version output Cisco Internetwork Operating System Software IOS (tm) 4000 Software (XX-J-M), Version 11.1(14), RELEASE SOFTWARE (fc1) Copyright (c) 1986-1997 by cisco Systems, Inc. Compiled Thu 04-Sep-97 21:33 by tlane Image text-base: 0x00012000, data-base: 0x0067166C ROM: System Bootstrap, Version 5.2(11a), RELEASE SOFTWARE ROM: 4000 Bootstrap Software (XX-RXBOOT), Version 10.2(11a), RELEASE SOFTWARE (f c1) R4000 uptime is 24 minutes System restarted by power-on System image file is "flash:xx-j-mz.111-14", booted via flash cisco 4000 (68030) processor (revision 0xC0) with 16384K/4096K bytes of memory. Processor board ID 5032615 G.703/E1 software, Version 1.0. Bridging software. SuperLAT software copyright 1990 by Meridian Technology Corp). X.25 software, Version 2.0, NET2, BFE and GOSIP compliant. TN3270 Emulation software (copyright 1994 by TGV Inc). 4 Serial network interfaces. 128K bytes of non-volatile configuration memory. 4096K bytes of processor board System flash (Read/Write) Configuration register is 0x2102 Any body got any ideas? Mike Bambic [EMAIL PROTECTED] _________________________________ FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED] _________________________________ FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
