That did the trick!
So, what does that tell me, that the 2511 thinks there is an incoming
exec session? Interesting...
Thanks a bunch,
John
>>> "Wang, Roger" <[EMAIL PROTECTED]> 3/28/01 4:47:03 PM >>>
You need "no exec" under the tty lines:
line 1 16
no exec
transport input all
HTH,
Rog
> -----Original Message-----
> From: John Neiberger [mailto:[EMAIL PROTECTED]]
> Sent: Wednesday, March 28, 2001 6:12 PM
> To: [EMAIL PROTECTED]
> Subject: Reverse Telnet (Not the usual question)
>
>
> How do I configure reverse telnet?? Just kidding...
>
> We have a very minor problem that I haven't figured out how to
resolve
> completely. We have a 2511 and we're using two of its async lines
for
> reverse telnet into the console ports of two routers. The problem I
> have is that often I get a 'connection refused' message.
> I'll clear the
> line at least three or four times and then RT works
> successfully. After
> I disconnect, if I wait too long it will refuse any new connections
> until I clear the line several times again.
>
> 'show users' shows the line as in use but idle. I have to keep
> clearing it until the line doesn't show up and then I can RT to the
> other router. Do any of you know the cause of this and how I might
be
> able to fix it? It's not a big deal, just a little annoying.
>
> Here is the output of a show line when it is denying access:
>
> RDIAL#sho line 8
> Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise
> Overruns
> Int
> * 8 TTY 9600/9600 - - - - - 39 0
> 0/0
> -
>
> Line 8, Location: "", Type: ""
> Length: 24 lines, Width: 80 columns
> Baud rate (TX/RX) is 9600/9600, no parity, 2 stopbits, 8 databits
> Status: Ready, Active
> Capabilities: No Flush-at-Activation
> Modem state: Ready
> Modem hardware state: CTS* DSR* DTR RTS
> Special Chars: Escape Hold Stop Start Disconnect Activation
> ^^x none - - none
> Timeouts: Idle EXEC Idle Session Modem Answer Session
> Dispatch
> 00:10:00 never none
> not set
> Idle Session Disconnect Warning
> never
> Login-sequence User Response
> 00:00:30
> Autoselect Initial Wait
> not set
> Modem type is unknown.
> Session limit is not set.
> Time since activation: 00:07:03
> Editing is enabled.
> History is enabled, history size is 10.
> DNS resolution in show commands is enabled
> Full user help is disabled
> Allowed transports are pad v120 telnet rlogin. Preferred is telnet.
> No output characters are padded
> No special data dispatching characters
>
>
>
> Thanks,
> John
>
> _________________________________
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to
[EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
