> HOWEVER.
>
> Always one of these............
>
> I have uncovered a "quirk" or bug that I can't find on CCO. Getting ready
> to open a Tac case on this one.
>
> If the router is reloaded, after it's up and just before the "Press return
> to get started!" line - I see this:
>
> "Secondary addresses not allowed with negotiated addresses"
>
> Processor board ID JAB024801KB (751772336)
> M860 processor: part number 0, mask 49
> Bridging software.
> X.25 software, Version 3.0.0.
> 6 Ethernet/IEEE 802.3 interface(s)
> 1 Serial network interface(s)
> 2 Serial(sync/async) network interface(s)
> 32K bytes of non-volatile configuration memory.
> 8192K bytes of processor board System flash (Read/Write)
> Secondary addresses not allowed with negotiated addresses
>
>
> Press RETURN to get started!
>
> ********
>
> and sure enough, the secondary address on E1/0 is gone.
>
> I can put it back in and the router does not complain. Save the config and
> everything is happy again! (until the next reload)
>
> Does anyone have a handle on that one?? Like what address is being
> negotiated??
>
This is problably well know bug in 12.1.2T IOS.
Upgrade/downgrade to something other.
Pawel/
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
