My ILS 1000 comes with both U and S/T interfaces... Only prob is I need
additional "optional" s/w to simulates Custom AT&T, etc.. any has the s/w ,
can tell me what's the diff...
""Nigel Taylor"" <[EMAIL PROTECTED]> wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> Fred,
> My first question would be which model did you get? The ILS 2000
> comes with support for both U and ST BRI interfaces, whereas the
> Demonstrator only supports the U interface. What does this mean...?
>
> You'll need two NT1's in order to make your connection if this is the
case.
>
> HTH
>
> Nigel.
>
> ----- Original Message -----
> From: Fred Danson <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Sent: Sunday, April 01, 2001 12:10 AM
> Subject: ISDN simulator problem
>
>
> > Hey Group,
> >
> > I just got my Teltone ISDN simulator in the mail, but I can't seem to
get
> it
> > working. The simulator, by default, is setup to use Basic-ni1. I
connected
> > both of my routers directly to the simulator using straight-through
cat5
> > cables. I then typed no shut on the bri0 interfaces and set the isdn
> > switch-type as basic-ni1 on both of the routers.
> >
> > When I type show isdn status, I get this:
> >
> > Router#show isdn status
> > The current ISDN Switchtype = basic-ni1
> > ISDN BRI0 interface
> > Layer 1 Status:
> > DEACTIVATED
> > Layer 2 Status:
> > Layer 2 NOT Activated
> > Layer 3 Status:
> > No Active Layer 3 Call(s)
> > Activated dsl 0 CCBs = 0
> > Total Allocated ISDN CCBs = 0
> >
> > With my basic configuration, shouldn't the layer 2 be working? Can
anyone
> > spot any problems with my setup?
> >
> > Thanks in advance,
> > Fred
> > _________________________________________________________________
> > Get your FREE download of MSN Explorer at http://explorer.msn.com
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
