If both of those networks are directly attached, your choice of routing
protocol is irrelevant. I would check the usual: host configurations,
IP addresses, subnet masks, etc.
If this isn't a production router, turn on debugging and see if that
gives you any clues. debug ip packet will show you if the packets are
being routed. Can you ping hosts on both networks from the router? If
so, this is probably a default gateway issue. The hosts don't know
where to send off-network responses.
Just a guess,
John
>>> <[EMAIL PROTECTED]> 4/3/01 9:42:29 AM >>>
Hello everyone, I have a problem and no it's not personal (hah!).I am
having
trouble getting a router to route between two networks (10.166.x.x /24
and
10.20.30.x /24). I have a cisco 1605 (running 11.2) that has two
ethernet
interfaces. On eth0 I have the 10.166.x.x network, on the other
10.20.30.x./24. I have eigrp enabled and in the routing table both
networks
show up, but I can't ping a host on the 10.166.x.x network from the
10.20.30.x.
I know this is very simple, but I am a simple man.
Thanks,
F.
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
