I'm running 12.1(1)T in a 3620 and from memory I believe 12.1(5)T in a 3660
both with NM2FE2W.
I'm fairly sure any T image after 12.1(1)T will do the trick. Certainly CCO
says so.
Cheers,
Gareth
""John Kurkjian"" <[EMAIL PROTECTED]> wrote in message
9aeiju$lmg$[EMAIL PROTECTED]">news:9aeiju$lmg$[EMAIL PROTECTED]...
> 1) IOS "T" does NOT support FE NM's, "XK" does.
>
> 2) If you put the flash in a 2600 to upgrade, how will the 2600 boot? As
> time consuming as it may be, use the console port to upload the
> image - OR- Use a PCMCIA flash card in a router that is up & running &
tftp
> the 3620 image to the card & use it to boot the new router, then
> copy to flash.(I used a 1601R to do this and it worked great)
>
> Good luck
>
> John
>
> P.S - you can increase the baud rate on the console port to speed things
up,
> just remember the rate for future console connections.
> "Thomas" <[EMAIL PROTECTED]> wrote in message
> 9aeg25$ig9$[EMAIL PROTECTED]">news:9aeg25$ig9$[EMAIL PROTECTED]...
> > Someone told me that IOS version followed with 'T' will support (like
> > 12.0(5)T...). Do you think the latest version 12.1.7 will support this
> > NM-2FE2W module? Thanks!
> >
> >
> >
> > "Nick Brooks" <[EMAIL PROTECTED]> wrote in message
> > [EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> > > 12.0.7XK is the first version to support the new combo modules
> > >
> > > Thomas wrote:
> > >
> > > > Hi All - I have a 3620 router and a NM-2FE2W module. What version
of
> > IOS
> > > > supports this NM-2FE2W on 3620? The router is currently has the
> > standard IP
> > > > IOS version installed. If a different IOS version is needed, is it
> > possible
> > > > if I place the flash of this 3620 router into a 2600 router and do
the
> > IOS
> > > > upgrade from there, then put it back to the 3620 once done???
Thanks
> > All!
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
