Hi,
Does anyone have any good URLs/articles of rules and procedures to building
the routing tables of RIP, IGRP (RIP and IGRP should be the same?) and OSPF?
'Coz I am reading the routing tables of 2 routers running IGRP and I
couldn't build the same routing tables as the routers did.
Your helping is needed. Thanks.
Dave
========================================
Here is the question. R1 is connected to R2 with a serial link.
==>R1# sh run
interface Ethernet0
ip address 171.68.178.196 255.255.255.192
interface Serial0
ip unnumbered Ethernet0
clock rate 20000
router igrp0
network 171.68.0.0
==>R2# sh run
interface Ethernet0
ip address 172.68.178.196 255.255.255.192
interface Serial0
ip unnumbered Ethernet0
router igrp0
network 172.68.0.0
==>R2# sh ip route
C 172.68.0.0/16 is directly connected, Ethernet0
171.68.0.0/16 is variably subnetted, 2 subnets, 2 masks
I 171.68.178.192/32 [100/8576] via 171.68.178.196, 00:00:49, Serial0
I 171.68.0.0/16 [100/8576] via 171.68.178.196, 00:00:49, Serial0
I couldn't figure how the below entry comes in:
I 171.68.178.192/32 [100/8576] via 171.68.178.196, 00:00:49, Serial0
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=1491&t=1491
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
