Usually this is from something at layer 2 or below. Verify that your
encapsulations are set the same and that you have good/correct cables. I
have had this problem in the past with bad cables connecting an external
DSU. Hope that helps
Tim
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
Tariq
Sent: Saturday, April 21, 2001 9:28 PM
To: [EMAIL PROTECTED]
Subject: Status is up and Line Protocol is down. [7:1508]
Hello Everybody.
I am getting very strange problem in my home network.
I am getting Status is up and line protocol is down message.
Please check the attached diagram. I am unable to coonect Serial 1 of Router
2 with Serial 1 of router 3
I applied clock rate 64000 command on serial 1 interface of Router 2.
Encapsulation on both ends is HDLC.
I changed keepalive but was no success. Default keepalive is 10.
Cable and interface is is 100% ok thats why status is up. Line Protocol is
down means that there is some problems on datalink layer.
I think that it could be some masking problem. Please see it and let me
know.
Thanks
Tariq
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=1751&t=1508
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
