Create a L3 rule to allow all ports and protocols then use an ACL to block
the ports and protocols that you do not want to hit the rule.
"Bradley J. Wilson" wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> It sounds like you want to create a VLAN, assign ports to the VLAN, and
then
> assign a single IP address to the VLAN. If this is the case, try this:
>
> int 1/1 [repeat on whichever interfaces you want]
> bridge vlan 1
>
> circuit VLAN1
> ip address 192.168.1.1 /24
>
>
> That should pretty much do it - you can then add services and content
rules
> from there. Don't forget a default route, too.
>
>
>
> ----- Original Message -----
> From: George Dodds
> To: [EMAIL PROTECTED]
> Sent: Thursday, May 03, 2001 7:11 AM
> Subject: OT: Arrowpoint port assignment [7:3020]
>
>
> I've got a pre cisco arrowpoint 800 and i'm wondering
> if it's possible to assign a group of ports to an ip
> address, currently i'm having to create individual
> rules with a single port assigned to the ip address.
>
> Cheers
>
> George
>
>
> =====
> George Dodds
>
> CCNA, MCP
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! Auctions - buy the things you want at great prices
> http://auctions.yahoo.com/
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=3089&t=3020
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
