I have set this up on 2/362X/5Xs without any trouble, using ISL rather than
dot1q, although can't imagine it would make any difference.
what do you not have connectivity to? try extended pings between the real
and vitrual interfaces on the routers with the appropriate subinterface as
the source address
can you post router interface configs and a "show standby brief"? Also
trunk config(s) and a "show vlan" and "sh vtp domain" from the switch(es)?
hth
Andy
inline also...
Bremen K H Lee wrote:
> Hi folks,
>
> I encounter some problem and hope that you folks can give me some idea.
>
> I have 2 2651, say A and B, connecting to a group of switches. Trunking
and
> VTP are running on the switch group. Each 2651 is connecting to the
switches
> on same VLANs.
>
> Say there is VLAN 1 and VLAN 2. Both 2651 are running trunking and dot1q
> encapsulation.
>
> Ok, FE0/0.1 of A and FE0/0.2 of B are on VLAN 1
> FE0/0.2 of A and FE0/0.2 of B are on VLAN 2
I assume that you mean FE0/0.1 of A & B are in VLAN1?
> I setup HSRP on both subinterface and router A is always the highest HSRP
> priority.
>
> I have a PC connecting or with IP address of VLAN 2 segment. I try to
ping
> from the PC to an interface of B but no response. But I can ping the
> subinterface of B FE0/0.2.
>
> Is there any issue running HSRP on vLAN subinterface or do I miss any
> configuration??
>
> Thanks bros.
>
>
> Cheers,
>
> Bremen
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=3900&t=3800
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
