Hey,
I have read through the archives and found information close to what I am
needing, but not exactly.
Here is the question...
I have (3) 3600 series routers connected by Frame-relay links. router#1 is
the main, router#2 and router#3 hang off of the main in a hub and spoke
config. I have a DHCP server behind router#1 that all subnets use for
address's. I am running EIGRP.
Router#2 and router#3 have "ip helper-address" statements for the DHCP
server. Router#2 can ping the DHCP server and its own serial interface and
get DHCP addresses, but router#3 can't ping the DHCP server or its own
serial interface, or get DHCP address's. Traffic passes fine, LMI is
correct, and PVC's are setup correctly. Both Router#2 and Router#3 have the
exact same config(beside network numbers, ip address's, and DLCI's).
What would cause a router not to be able to ping it own serial interface???
"show ip int s0" says (up,up) and LMI are increasing every 10 seconds..
Please help....cisco TAC can't even solve this one...
I am not a member of groupstudy (yet), so please respond to
"[EMAIL PROTECTED]"
Thank you guys!!
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=4435&t=4435
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
