What does your Sho Version say @ the bottom, concerning the config-register ??? My guess is that you do not have it in 0x2102. If my memory serves me correctly, I had one of these 2502's (bare bones model) & it was not setup like a regular 2500. I think it had ROM's (10.0) & 4 Megs of FLASH only. Phil ----- Original Message ----- From: Jerry Seven To: Sent: Tuesday, May 15, 2001 7:48 PM Subject: 2502: Always initial configutation dialog in the boottime [7:4618] > Hi Group, > > I just got a 2502, it runs 10.3(16), I configured it and use "copy run > start" to save it, but next time when I boot the box, I still got the > initial configuration dialog: > > --- System Configuration Dialog --- > > At any point you may enter a question mark '?' for help. > Use ctrl-c to abort configuration dialog at any prompt. > Default settings are in square brackets '[]'. > Would you like to enter the initial configuration dialog? [yes]: no > > I pressed no, then I found everything I configured before reload is not > there. "show start" still shows correct config but it's not used, for "show > run" gives me blank config. > > I know the image is quite old, but without solving this problem I couldn't > upgrade it. > > Anyone know what's wrong here? > > Thanks, > Jerry > > > _________________________________________________________ > Do You Yahoo!? > Get your free @yahoo.com address at http://mail.yahoo.com > FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED] Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=4629&t=4629 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
