Hi Gary,
Actually, I had the same question but got no reply from anyone. So far, I
have been using a 2501 as a frame relay switch. I would like to use the 1600
but it just does not take the frame-relay route and the frame-relay
intf-type dce commands. I tried the cisco web-site but no luck. Actually,
here is my question that I posted yesterday:
Is it possible to configure a 1602 as a frame-relay swich like a 2501? If a
1602 has 2 56kbps wic cards, can you connect another 2 1602's to this and
setup frame relay? I see that the 1602 takes the frame-relay switching
command and also encap frame-relay, frame-relay lmi-type.. commands. How do
I specify the frame-relay intf-type dce and the frame-relay route 100 serial
1 101...commands?
Please let me know if you get any replies. Thank you.
Niraj
>From: "Gary Hughes"
>Reply-To: "Gary Hughes"
>To: [EMAIL PROTECTED]
>Subject: 1600's - Using to make a Frame Switch [7:4643]
>Date: Tue, 15 May 2001 23:52:35 -0400
>
>Anybody know the config's to make a 4 port Frame-Switch from 2 1600's (both
>with 2 serial ports)
>FAQ, list archives, and subscription info:
>http://www.groupstudy.com/list/cisco.html
>Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=4650&t=4643
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
