On Wed, 16 May 2001, Circusnuts wrote:
> It shouldn't be any different than a 4 port router. I'm not sure what is
> supported in the 1600 IOS, but here is a basic template of the Telco Cloud
> config.
Only difference would be needing to switch to/from a tunnel between the
routers, or over IP addresses directly if FR switching supports that (I
know X25 switching does, can't remember whether FR does). There's an
example using tunneling in the 11.3 FR configuration guide.
> interface Serial0
> no ip address
> encapsulation frame-relay
> frame-relay lmi-type ansi
> frame-relay intf-type dce
> frame-relay route 102 interface Serial1 201
> frame-relay route 103 interface Serial2 301
> frame-relay route 105 interface Serial3 501
> !
> interface Serial1
> no ip address
> encapsulation frame-relay
> frame-relay lmi-type ansi
> frame-relay intf-type dce
> frame-relay route 201 interface Serial0 102
>
> Phil
>
> ----- Original Message -----
> From: Gary Hughes
> Sent: Tuesday, May 15, 2001 11:52 PM
> Subject: 1600's - Using to make a Frame Switch [7:4643]
>
> > Anybody know the config's to make a 4 port Frame-Switch from 2 1600's
> (both
> > with 2 serial ports)
--
"Someone approached me and asked me to teach a javascript course. I was
about to decline, saying that my complete ignorance of the subject made
me unsuitable, then I thought again, that maybe it doesn't, as driving
people away from it is a desirable outcome." --Me
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=4663&t=4643
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
