The pin placement is outlined either as W or N's.
http://www.cisco.com/univercd/cc/td/doc/product/core/cisagspl/agscfig/34084.
htm#xtocid2857013
http://www.cisco.com/univercd/illus/h/78/h1978.gif
These jumpers are located in the front of the card, centered. Remember-
with the AGS's you cannot set the Clock Rate command without a cable plugged
into the interface you are configuring. You may be seeing something like
"Clockrate not allowed on a DTE interface."
Phil
----- Original Message -----
From: Cisco Kidd
To:
Sent: Wednesday, May 16, 2001 1:10 AM
Subject: AGS+ DCE mode? [7:4655]
> Hello, I am having a problem getting my serial ports to act in DCE mode.
> I have changed the jumpers to the appropriate places, but still have no
> luck. When I issue the "show controller mci" command it tells me that
> the interfaces are in DTE mode, except for one, which is recognized as
> unknown. I have 4 serial ports. Two are hooked up to one card, and two
> to another card. I have changed the jumpers correctly for serial ports 2
> and 3( I used the diagram from cisco's website, labeled CSC-SCI, which
> looked exactly like the card for serial ports 2 and 3). Here is the link
> to the diagram,
>
http://www.cisco.com/univercd/cc/td/doc/product/core/cisagspl/agscfig/43412.
htm#xtocid1591 I
> was unable to change the jumpers for serial 0 and 1 because I couldnt
> find the jumpers for that card...it kinda looked like CSC-MCI but the
> jumpers were not in the same place. I have tried to issue the "clockrate"
> command on all serial interfaces but it says I cannot because it is in
> DTE mode. I am stuck at this point. Does it have to do with the
> microcode on each controller? Do I need to upgrade this? Any help would
> be appreciated immensely!!!! Paul
>
> ------------------------------------------------------------------------
>
> Get your FREE download of MSN Explorer at http://explorer.msn.com
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=4665&t=4655
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
