Yes- the AGS+ V.35 (Winchester) interfaces can be set to DCE. You must make
the change on the Serial card. The cable you need is a crossover DTE to DCE
pin. The traditional DTE/ CSU cable will not work. I haven't ordered these
cables before, but I have gotten quotes from Dave @
http://pacificcable.com/CiscoCables.htm. I believe the cost is around $50 &
he did not have them pre-made.
Good Luck !!!
Phil
----- Original Message -----
From: nathan cruz
To:
Sent: Sunday, May 20, 2001 9:13 PM
Subject: AGS+ V.35 34 PIN Applique can it be DCE?? [7:5203]
> Group,
>
> Looked in the archives about setting the serial cables to DCE. I've set
the
> jumpers on the MCI card to 41 and 51. I also experimented with taking the
one
> jumper on the applique off but I still can't seem to get it to pick up the
> DCE
> side.
>
> So I have two questions?
>
> 1. Can the older V.35 34 pin applique be set to DCE?
>
> 2. Can I use the CAB-v35mt cable which would usually be plugged from a dsu
to
> the hd60 on the 2500.
> Or is there a difference in the pin outs?
>
> Thanks in advance for all advice.
>
> Nathan
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=5208&t=5203
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
