You can also use a single jack as a loop to bring the interface up. You just
need two copper wires and a jack. Make sure wire 1 goes from pin1 to pin 8
in the jack and wire two goes from pin 2 to pin 7 in the jack. Plug the jack
in and you should get an up up status.
This is good for lab if you want to add another network and then advertise
it say over the ethernet interface for any routing protocol. Just remove the
plug and the interface goes down, hence the network goes down, get for
debug and troubleshooting.
Don
----- Original Message -----
From: "Brian Dennis"
To:
Sent: Friday, May 18, 2001 11:43 PM
Subject: RE: 1605 56k csu dsu to 1602 CSU DSU [7:5091]
> www.cisco.com/warp/public/471/75.html
>
>
> Brian Dennis, CCIE #2210 (R&S)(ISP/Dial) CCSI #98640
> 5G Networks, Inc.
> [EMAIL PROTECTED]
> (925) 260-2724
>
> > -----Original Message-----
> > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
> > Randy Espiritu
> > Sent: Friday, May 18, 2001 10:52 PM
> > To: [EMAIL PROTECTED]
> > Subject: 1605 56k csu dsu to 1602 CSU DSU [7:5091]
> >
> >
> > Hi All
> >
> > Anyone know how to configure 2 1600 series router connecting both
> > WIC-1DSU-56K from each router using cross over cable
> >
> > thanks all in advance
> > FAQ, list archives, and subscription info:
> > http://www.groupstudy.com/list/cisco.html
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=5243&t=5091
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
