Did u try dialer dtr??? Waqar --- NRF wrote: > Consider this. I have 2 2610's, each with a > WIC-1DSU T-1 card in them. I > have these T-1's connected back to back. I have > tried putting IP addreses, > using encap ppp, and everything works cool, exactly > the way I would expect > it to work. So I know the cards and the cable and > all that are working > fine. > > Now, I want to try to have the T-1 interfaces > invoked via Dialer interfaces. > Why? Because eventually I want to get 2 more of > these T-1 cards, and > install one in each (so each router has 2 of them) > and then run ppp > multilink where I bond the 2 T-1's together to form > a 3 Mb pipe. > > But I just cannot do it. Specifically, I have tried > various ways to get the > Dialer interface to bond to the T-1's (Serial 0/0). > It never works. For > example, I create rotary groups. It doesn't work. > Then I try dialer pools. > It also doesn't work. Everything I have tried > doesn't work. > > For example, if I try to use dialer pools, then the > router demands a dialer > string. So I give it a dialer string. The Dialer > interface then apparently > tries to dial this string, which of couse fails > because in a back2back T-1, > there is nothing to dial. So if I try a rotary > group, somehow the dialer > interface never properly seizes the T-1. Instead I > get an error like this, > whatever the heck it means: > > r1#ping 192.168.20.2 > > Type escape sequence to abort. > Sending 5, 100-byte ICMP Echos to 192.168.20.2, > timeout is 2 seconds: > ..... > Success rate is 0 percent (0/5) > r1# > 01:25:59: Se0/0 DDR: rotor dialout [priority] > 01:26:01: Se0/0 DDR: rotor dialout [priority] > 01:26:03: Se0/0 DDR: rotor dialout [priority] > 01:26:05: Se0/0 DDR: rotor dialout [priority] > 01:26:07: Se0/0 DDR: rotor dialout [priority] > > > OK, now I have seen several CCO examples (for > example the examples on PPP > multilink) where they put a serial interface (not an > ISDN or an async int, > but an actual serial interface) under a Dialer > interface. But what can I > say, it has never worked for me, not once. The only > thing that can I can > think of is that all those CCO examples use 2500's, > whereas I got 2600's > here. But it shouldn't matter (or should it?). > > So, has anybody (especially somebody with a 2600 > with a T-1 WIC)ever > successfully put a serial interface under a Dialer > interface and gotten them > to bond correctly ? If so, could you shoot me a > config? > > Thanx > FAQ, list archives, and subscription info: > http://www.groupstudy.com/list/cisco.html > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED] __________________________________________________ Do You Yahoo!? Yahoo! Auctions - buy the things you want at great prices http://auctions.yahoo.com/ Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=5562&t=5562 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
