Jason,
Post us your config and we could probably get to the problem much quicker.
Also can you tell us the Ip addresses / subnet masks and default gateway
which is setup on the pc's.
Cheers
-----Original Message-----
From: Jason Witover [mailto:[EMAIL PROTECTED]]
Sent: 30 May 2001 21:39
To: [EMAIL PROTECTED]
Subject: Can't Ping e0/0 [7:6513]
I have a 2611 with a t0/0 an e0/0 and a s0/0.
The router was set up by someone else who made it a source bridge using the
s0/0 interface. I am trying to interface a tiny network of 5 PC's that are
on a 3com switch to that e0/0 interface. I gave the interface an IP address
on the same schema as the 5 pc's and gave the no shut command on it. I get a
link light on both the switch and the router. When I do a show interface
e0/0 it says the interface is up and the line protocol is up. I can ping my
own e0/0 interface but every other pc on the network can not ping that
interface, nor can the router ping any other computer.
I also typed in ip routing to see if that would fix it, but it did not. I
shut the interface and no shut the interface a few times, but still no help.
I know you are all much much smarter than me.. so PLEASE teach me the errors
of my ways.
Thanks group!
Jason
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=6519&t=6513
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]