try the following:
conf t
no service config
hth!
Sam.
----- Original Message -----
From: "Manoj Sekhar"
To:
Sent: Saturday, June 16, 2001 10:35 PM
Subject: 801 ERROR urgent [7:8826]
> Hi all,
>
> I am getting the following error when I boot up the 801 router.
>
> %Error opening tftp://255.255.255.255/network-confg (Socket error)
> %Error opening tftp://255.255.255.255/cisconet.cfg (Socket error)
> %Error opening tftp://255.255.255.255/routera-confg (Socket error)
> %Error opening tftp://255.255.255.255/routera.cfg (Socket error)
>
> The output of the 801 boot seqence and config is as given below.
>
> Please help.
>
> TinyROM version 1.4(1)
> 19:38 11/07/00
> Copyright (c) 1998-2000 by cisco Systems, Inc.
> All rights reserved.
>
> POST ............ OK. 4MB DRAM, 8MB Flash.
>
> Accessing flash:c800-y6-mw.121-3.XG2
>
> Booting "c800-y6-mw.121-3.XG2" ...,
> Restricted Rights Legend
>
> Use, duplication, or disclosure by the Government is
> subject to restrictions as set forth in subparagraph
> (c) of the Commercial Computer Software - Restricted
> Rights clause at FAR sec. 52.227-19 and subparagraph
> (c) (1) (ii) of the Rights in Technical Data and Computer
> Software clause at DFARS sec. 252.227-7013.
>
> cisco Systems, Inc.
> 170 West Tasman Drive
> San Jose, California 95134-1706
>
>
>
> Cisco Internetwork Operating System Software
> IOS (tm) C800 Software (C800-Y6-MW), Version 12.1(3)XG2, EARLY
> DEPLOYMENT RELEASE SOFTWARE (fc1)
> TAC:Home:SW:IOS:Specials for info
> Copyright (c) 1986-2000 by cisco Systems, Inc.
> Compiled Mon 13-Nov-00 17:27 by detang
> Image text-base: 0x000EE000, data-base: 0x00654000
>
> Cisco C801 (MPC850) processor (revision 1) with 43464K bytes of virtual
> memory.
> Processor board ID JAD05030E7A
> CPU part number 0x2101
> Bridging software.
> Basic Rate ISDN software, Version 1.1.
> 1 Ethernet/IEEE 802.3 interface(s)
> 1 ISDN Basic Rate interface(s)
> 4M bytes of physical memory (DRAM)
> 8K bytes of non-volatile configuration memory
> 8M bytes of flash on board (4M from flash card)
>
> %Error opening tftp://255.255.255.255/network-confg (Socket error)
> %Error opening tftp://255.255.255.255/cisconet.cfg (Socket error)
> %Error opening tftp://255.255.255.255/routera-confg (Socket error)
> %Error opening tftp://255.255.255.255/routera.cfg (Socket error)
>
>
> Press RETURN to get started!
>
>
> 00:00:21: %LINK-3-UPDOWN: Interface Ethernet0, changed state to up
> 00:00:22: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0,
> changed state to up
> 00:00:25: %LINK-5-CHANGED: Interface BRI0, changed state to
> administratively down
> 00:00:25: %SYS-5-CONFIG_I: Configured from memory by console
> 00:00:26: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0, changed
> state to down
> 00:00:26: %SYS-5-RESTART: System restarted --
> Cisco Internetwork Operating System Software
> IOS (tm) C800 Software (C800-Y6-MW), Version 12.1(3)XG2, EARLY
> DEPLOYMENT RELEASE SOFTWARE (fc1)
> TAC:Home:SW:IOS:Specials for info
> Copyright (c) 1986-2000 by cisco Systems, Inc.
> Compiled Mon 13-Nov-00 17:27 by detang
> 00:00:26: %LINK-5-CHANGED: Interface Ethernet0, changed state to
> administratively down
> 00:00:27: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0,
> changed state to down
>
> RouterA#sh run
> Building configuration...
>
> Current configuration:
> !
> version 12.1
> service config
> no service pad
> service timestamps debug uptime
> service timestamps log uptime
> no service password-encryption
> !
> hostname RouterA
> !
> boot config flash:nvram
> enable secret 5 $1$nTbn$GQVW3zqE.sEBllYS0y6Bt0
> enable password cisco
> !
> ip subnet-zero
> !
> isdn switch-type basic-net3
> !
> interface Ethernet0
> no ip address
> shutdown
> no cdp enable
> interface BRI0
> no ip address
> shutdown
> isdn switch-type basic-net3
> no cdp enable
> no ip http server
> ip classless
> dialer-list 1 protocol ip permit
> dialer-list 1 protocol ipx permit
> bridge 1 protocol dec
> line con 0
> exec-timeout 0 0
> stopbits 1
> line vty 0 4
> password cisco
> login
> no rcapi server
> end
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=8828&t=8826
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
