Here is a link that may answer some questions about HSRP groups, and what it
could be used for.
http://www.cisco.com/warp/public/619/7.html
Best Regards,
Eric Hoffman
Senior Systems Engineer
MCP, CCNA, CCNP
Computer Professionals International
-----Original Message-----
From: Marc [mailto:[EMAIL PROTECTED]]
Sent: Friday, June 29, 2001 4:03 PM
To: [EMAIL PROTECTED]
Subject: Re: HSRP [7:10428]
HSRP is for router redundancy, not WAN circuit redundancy. If you wanted to
have internet or WAN circuit redundacy, you would of course use two lines,
have equal-cost routes (two default routes...etc) and that's all that's
involved. HSRP not needed for WAN load-balancing/redundancy...
Marc
"Sam Sneed" wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> I was doing a little research on HSRP and had a question for anyone who
has
> configured it. I read the whole RFC 2281 and could not find my answer
there.
> If you have two routers running HSRP with T1 lines to the internet, 1 is
the
> standby and one is the active. Does all traffic only go through the active
> at all times unless it dies? If so isn't it a waste not ever utilizing the
> T1 line thats on standby (of course until the active fails)?
>
> If bandwidth exceeded 1.5MB would the second router kick in to share the
> load or would it totally take over?
>
> With these 2 routers acting as a single virtual router would throughput
> ever be able to exceed 1.54 MB assuming each has its own T1 connection?
>
> thanks
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=10434&t=10428
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]