I know you know this stuff Tim, but did you set the DCE settings on the CSC card & also set clockrate on the DCE side ??? I've spent many a night (late !!!) with these AGS Up/Down Serial interfaces. I've I wasn't so sure the router would pull my back out, I would have pitched it :o) Phil ----- Original Message ----- From: "Tim Medley" To: Sent: Tuesday, July 03, 2001 10:51 AM Subject: AGS+ crossed over to 2610, Serial cable length issue? [7:10810] > I've finally decided to sit down and try to troubleshoot what I thought > was a faulty serial port on my AGS+. > > I have a 2610 with a WIC-2T connected to my AGS+ via a CAB-SS-V35MT and > a CAB-VCF. The CAB-VCF is from pacific cables and is a 26pin DCE to a > V.35 winchester cable. The CAB-VCF is 6 feet long and the CAB-SS-V35MT > is 10 feet long; so I have a 16 foot crosover cable. > > When I cable the two routers together and just configure a simple point > to point connection, with the following config: > > AGS+ > int s2 > ip address 100.100.100.1 255.255.255.252 > encap ppp > no shut > > 2610 > int s0/0 > ip address 100.100.100.2 255.255.255.252 > encap ppp > no shut > > The serial interfacces come up/up but then after a second or two line > protocol goes down on both sides and they become up/down. > > I thought the AGS+'s serial interface was bad (I had a bad applique a > while back). So I moved to a different interface on the AGS+, same > situation. > > I then decided to try a different router, I replaced the AGS+ with a > CGS, and I got the same results. > > I now think the issue is with the cable. a) I could have a bad cable. b) > the cable I have could be two long. I have replaced the CAB-SS-V35MT, > with no luck. What kind of issues would I see if the cable was too long? > Would I see the issue I am experiencing? I'm getting ready to call > Pacific Cable and order another CAB-VCF. > > tim > > > > > Tim Medley - CCNP+Voice > Network Architect > VoIP Group > iReadyWorld > > 704-943-3615 - Phone > 704-943-3660 - Fax > 877-6-iReady - Helpdesk Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=10814&t=10814 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
