I wasn't that brave. I did it on a 2600 series running OSPF, BGP, NAT
&
ACL'S in a lab environment. Result: CRASH CITY!
Prof. Tom Lisa, CCAI
Community College of Southern Nevada
Cisco Regional Networking Academy
Chuck Larrieu wrote:
for proof of this, issue a "debug all" command on a production router
and
watch the fun begin ;->
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, July 25, 2001 9:02 AM
To: [EMAIL PROTECTED]
Subject: Re: Can 2501 handle two T1s [7:13733]
Hi
If you are just routing you should be fine. However if you are doing
NAT,
ACL, policy based routing or anything else that is CPU consuming you
are
likely to have some problems. Keep in mind that a Cisco router will
start
dropping packets at about 70% CPU and be totally brain dead at about
90%
CPU.
HTH
--
John Hardman CCNP MCSE
""Frank Kim"" wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> Hey guys,
> I know no one in the world would put two T1s on a 2501 router. But
I
> maybe doing this soon. I am currently using a 7200 router for my
two T1s
> but I feel like taking it offline and sell it to pay for my ECP1
and my
> trip to San Jose for the lab test. So I'm going take out my 2501
and see
> if it can handle two T1s which is constantly pushing at 2.8-3.0
mbps all
> the time. Has anyone done this before? Am I going to blow up this
> router? Will the cpu utilization go skyrocket? Thanks for any
advice.
>
> -Frank
[EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=13901&t=13733
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
