Hi All,
I got kinda the same problem, but it is on the real 6509 w/ 2 sup and 2
MSFCs. Based on your message below, it seems to resolve the confusion
between priority in groups. However, beside NAT, I also have EIGRP running.
EIGRP does load balancing on both cards, is there a workaround for this?
Also, let say I have Vlan 10 as the outside NAT interfaces on both MSFCs, so
now with the load balancing of EIGRP, the NATed package still don't know
with VLAN 10 it should go to (VLAN 10 on the first card or the second
card?). Is it possible that I can have the same VLAN 10 on both cards, but
they are on different group?
Thanks All in advance! I really need your help here, since whoever setup
the 6509 in our production didn't have it redundancy. We tried to configure
this 6509 to do its primary job, redundancy while not breaking anything else
(NAT for instant).
Thomas N.
""Kevin Wigle"" wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> Correct, but if you use secondary ip addresses and a different group
number
> you can.
>
> If the original poster wanted 2 HSRP groups where one group was active on
> RouterA on netA and the other was active on RouterB on netB - both groups
> would co-exist and not bother each other.
>
> If RouterA failed then RouterB would become active on netB as well as
> already active on netA.
>
> The opposite holds true of course.
>
> This is also helpful in trying to load balance HSRP by splitting the user
> community manually, half to RouterA and half to RouterB - and maintain
fault
> tolerance.
>
> Kevin Wigle
>
> ----- Original Message -----
> From: "Erick B."
> To:
> Sent: Monday, 30 July, 2001 06:51
> Subject: Re: HSRP [7:14135]
>
>
> > I don't quite understand what your asking, but...
> >
> > IOS will not let you configure the same HSRP/standby
> > address or IP subnet on multiple LAN interfaces. You
> > would have to use a different IP subnet on each
> > Ethernet interface with a HSRP/standby address in that
> > subnet.
> >
> > Were you asking that or ?
> >
> > --- BASSOLE Rock wrote:
> > > Hello group,
> > >
> > >
> > > I want to know if there are problems on doing a
> > > double HSRP (ethernet1 and
> > > ethernet0) with 2 routers (same configuration).
> > > Have you ever incounter any
> > > problems (Duplicate addresse, NAT, ...).
> > >
> > > Thank you.
> > >
> > > Rock BASSOLE
> > > Til: +33 (0) 1 45 96 22 03
> > [EMAIL PROTECTED]
> >
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Make international calls for as low as $.04/minute with Yahoo! Messenger
> > http://phonecard.yahoo.com/
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=15919&t=14135
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
