Thanks. I think I have put the ip pim x command.
----- Original Message -----
From: "Marcos Hernandez"
To:
Sent: Monday, September 10, 2001 11:17 PM
Subject: Re: Multicast traffic tunnelling [7:19267]
> You are missing the ip pim x command withing the Interface Tunnel config.
>
>
> ""kwock99"" wrote in message
> [EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> > Hi All,
> >
> > Just checking anyone has the experience on the multicast tunnelling
> > configuration.
> >
> > I have configured three routers to use the Sparse mode for multicast
> traffice
> > and they works perfectly.
> >
> > After I remove the centre router command, "ip pim sparse-mode" and try
to
> use
> > the tunnel to conect the first and third router. I have problem.
> >
> > I use the following command to config the tunnel within the first and
> third
> > router.
> >
> > interface tunnel0
> > ip unnumbered type number
> > tunnel source ip-addressa
> > tunnel destination ip-address
> >
> > It seems that the mulitcast traffic does not go to the tunnel
> automatically.
> > I
> > have tried the ip mroute 0.0.0.0 0.0.0.0 tunnel0. And it does not help.
> For
> > simplicity, I use all the ethernet port for the connection.
> >
> > Any suggestion would be highly appreciated.
> >
> >
> > Francis
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=19279&t=19267
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
