You can use dialer profiles to dial multiple locations. To accomplish
this you would create a virtual interface with interface dialer1 and
place relevant commands under that interface. Hope this helps
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of
Mohammed Saro
Sent: Tuesday, September 18, 2001 2:05 AM
To: [EMAIL PROTECTED]
Subject: BRI D channel [7:20241]
the D channel is the channel that takes the ip address so how can i
dial to
two different locations with the same BRI interface
and the other question about cisco BOD how can i use dialer
load-threshold
load
without enabling MLPPP what will happen to ips is it will take two
different
ips ?
Best Regards,
Mohammed Saro
Network Engineer
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=20263&t=20241
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
