Marcus,
I'm not sure what the problem is, but possibly the image is bad/not
there. Try this.
http://www.cisco.com/warp/public/701/61.html
1.. Connect to the router with the following terminal settings:
1200 baud rate
No parity
8 data bits
1 stop bit
No flow control
You no longer see any output on your screen. This is normal.
1.. Power cycle (switch off and then on) the router and press the spacebar
for 10-15 seconds. This generates a signal similar to the break sequence.
2.. Disconnect your terminal and reconnect with a 9600 baud rate. You
should now be in ROM Monitor mode.
>From here, you can see what's on the flash, as well as tftp or boot from the
flash.
-Sean
""marcus xxxxxx"" wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> I just got a 4700M router through an auction. I think the guy is honest so
I
> doubt he sent me a bad router. Plus, he had a show version in the auction,
> but I have reason to believe he just sells stuff he gets, so might not
even
> know how to get a show ver but copied it from who sold him the router.
>
> I only have experience with 2500 routers. I connected to a 2500 router and
> got output, then without changing anything, took out the console cable
from
> the 2500 and put it in the 4700M with a console cable sub25 to rj45
adapter
> that comes standard with cisco console kits. Nothing appears. I've
searched
> cisco.com and believe I've found the hyperterminal settings are to be the
> same as a 2500...9600, 2 stop bit, no hardware flow, so am left thinking
the
> adapter is bad, but brand new (I believe 3rd party console kits). The
power
> light comes on in front. There are 3 2port ethernet modules plugged in it.
> The OK light only comes up on the far left one. But, I also put in a live
> ethernet cable into each port and properly get a flashing link light, so
> think those are fine.
>
> Does anyone know what I'm doing wrong?
>
> Thanks,Marcus
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=20631&t=20630
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
