I have a 6509 with an MSM installed and have configured virtual interfaces
for inter-vlan routing.  I have created a route-map on the MSM but can not
apply it to any interface.  When I type the command "ip policy route-map" in
interface configuration mode, the command is unrecognized:

MSM(config)#int port-ch 1.3
MSM(config-subif)#ip ?
Interface IP configuration subcommands:
  access-group        Specify access control for packets
  accounting          Enable IP accounting on this interface
  address             Set the IP address of an interface
  authentication      authentication subcommands
  bandwidth-percent   Set EIGRP bandwidth limit
  broadcast-address   Set the broadcast address of an interface
  cgmp                Enable/disable CGMP
  directed-broadcast  Enable forwarding of directed broadcasts
  dvmrp               DVMRP interface commands
  hello-interval      Configures IP-EIGRP hello interval
  helper-address      Specify a destination address for UDP broadcasts
  hold-time           Configures IP-EIGRP hold time
  igmp                IGMP interface commands
  irdp                ICMP Router Discovery Protocol
  load-sharing        Style of load sharing
  mask-reply          Enable sending ICMP Mask Reply messages
  mobile              Mobile Host Protocol
  mroute-cache        Enable switching cache for incoming multicast packets
  mtu                 Set IP Maximum Transmission Unit
  multicast           IP multicast interface commands
  ospf                OSPF interface commands
  pim                 PIM interface commands
  probe               Enable HP Probe support
  proxy-arp           Enable proxy ARP
  rarp-server         Enable RARP server for static arp entries
  redirects           Enable sending ICMP Redirect messages
  rip                 Router Information Protocol
  route-cache         Enable fast-switching cache for outgoing packets
  sdr                 Session Directory Protocol interface commands
  security            DDN IP Security Option
  split-horizon       Perform split horizon
  summary-address     Perform address summarization
  unnumbered          Enable IP processing without an explicit address
  unreachables        Enable sending ICMP Unreachable messages
  verify              Enable per packet validation

MSM(config-subif)#ip policy route-map cwvpn ?
% Unrecognized command

Are rout-maps not possible on an MSM?  Am I missing something?  Any help
would be much appreciated!




Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=22058&t=22058
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]

Reply via email to