Is it really an MSFC?? Your not applying a route map to a VLAN, looks like a portchannel to me!?!?
Dave "Wilson, Christian" wrote: > > I have a 6509 with an MSM installed and have configured virtual interfaces > for inter-vlan routing. I have created a route-map on the MSM but can not > apply it to any interface. When I type the command "ip policy route-map" in > interface configuration mode, the command is unrecognized: > > MSM(config)#int port-ch 1.3 > MSM(config-subif)#ip ? > Interface IP configuration subcommands: > access-group Specify access control for packets > accounting Enable IP accounting on this interface > address Set the IP address of an interface > authentication authentication subcommands > bandwidth-percent Set EIGRP bandwidth limit > broadcast-address Set the broadcast address of an interface > cgmp Enable/disable CGMP > directed-broadcast Enable forwarding of directed broadcasts > dvmrp DVMRP interface commands > hello-interval Configures IP-EIGRP hello interval > helper-address Specify a destination address for UDP broadcasts > hold-time Configures IP-EIGRP hold time > igmp IGMP interface commands > irdp ICMP Router Discovery Protocol > load-sharing Style of load sharing > mask-reply Enable sending ICMP Mask Reply messages > mobile Mobile Host Protocol > mroute-cache Enable switching cache for incoming multicast packets > mtu Set IP Maximum Transmission Unit > multicast IP multicast interface commands > ospf OSPF interface commands > pim PIM interface commands > probe Enable HP Probe support > proxy-arp Enable proxy ARP > rarp-server Enable RARP server for static arp entries > redirects Enable sending ICMP Redirect messages > rip Router Information Protocol > route-cache Enable fast-switching cache for outgoing packets > sdr Session Directory Protocol interface commands > security DDN IP Security Option > split-horizon Perform split horizon > summary-address Perform address summarization > unnumbered Enable IP processing without an explicit address > unreachables Enable sending ICMP Unreachable messages > verify Enable per packet validation > > MSM(config-subif)#ip policy route-map cwvpn ? > % Unrecognized command > > Are rout-maps not possible on an MSM? Am I missing something? Any help > would be much appreciated! -- David Madland Sr. Network Engineer CCIE# 2016 Qwest Communications Int. Inc. [EMAIL PROTECTED] 612-664-3367 "Emotion should reflect reason not guide it" Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=22071&t=22058 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
