Dear all, Before I take the leap into the lab (2 weeks to go now), I have a question which has dogged me for a while now. Scenario below.
Router 1 has the following interfaces, Lo0, Eth0/0, S0/0, S0/1 and say Fast0/1. Router 2 has the following interfaces Lo0, Lo1, Eth 0/1, S0/0. Between Router 1 (s0/0) and Router 2 (s0/0) we are running say OSPF. On router 1 (e0/0 and s0/1) we are running RIP. On Router 2 (e0/1 and lo1) we are also running Rip. Router 1 (lo0, s0/1) and Router 2 (lo0) are running Eigrp. Now for the questions 1. On router 1 OSPF process is running Q: should I put lo0,e0/0, fast0/1 and s0/1 as passive interface ??? This worries me quite a bit as the argument of if you dont put the network command under ospf then ospf will not run on that interface...BUT I have been told that you should ALWAYS put every "in use" interface into passive if it is not being used under the routing process. 2. This is not a question but a sanity check that for EIGRP and RIP then the "norm" rules of passive interfaces apply. Thanks for anyones help in clearing this annoying matter up. Robert McCallum Ext 730 3448 DDI : 01415663448 Mobile : 07818002241 Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=24771&t=24771 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
