Pierre, Hi! You have the wrong switch type configured for the Simline2. You want:
ISDN switch-type basic-net3 Also, this switch type does NOT use spids! FYI thanks, -Brad Ellis CCIE#5796 (R&S / Security) Network Learning Inc [EMAIL PROTECTED] used Cisco gear: www.optsys.net CCIE Labs, racks, and classes: http://www.ccbootcamp.com/quicklinks.html ""Pierre-Alex J. Guanel"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > I am using the Slimline 2 ISDN simulator from PDS technologies. > > I cannot get the SPID to be accepted. (See below) > > > ISDN BRI0 interface > dsl 0, interface ISDN Switchtype = basic-5ess > Layer 1 Status: > ACTIVE > Layer 2 Status: > TEI = 64, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHE > TEI 64, ces = 1, state = 4(await init) > spid1 configured, no LDN, spid1 sent, spid1 NOT valid > > I have not modifed the default phone numbers 1111 and 2222 configured on > Slimline > > Below are my configs for bri0 > interface BRI0 > ip address 10.0.0.1 255.255.255.0 > encapsulation ppp > no ip route-cache > no ip mroute-cache > dialer map ip 10.0.0.2 1111 > dialer-group 1 > isdn switch-type basic-5ess > isdn spid1 2222 > > Is there a default LDN number I have to configure? > > Pierre-Alex Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=27369&t=27365 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]