Hello Pierre, You are correct, the Simline 2 does not support SPID's but it will work perfectly when you select the switch type on your router to NET3 which actually emulates the basic call control of the newer ETSI Euro ISDN network.
The Simline 2 supports ETSI Euro ISDN and is pre-configured for the latest numbering plan which is 'single number'. To call port 2 from port 1 you dial 2222 for the first bearer (B) channel and then 2222 again for the second bearer channel. If you want to dial from port 2 to port 1 you simply dial 1111 twice. These default numbers can be changed through the Simline software allowing any number up to 30 digits to be entered for each bearer channel if you would like to make it more realistic. Once you have changed the protocol supported on your router you may wish to monitor the signaling which can be done via the PC host used with the Simline 2 by clicking on trace and entering a name if you wish to record the file or clicking cancel if you just wish to look without recording. I hope that this helps to get you going, please do not hesitate to call or e-mail if you have any more questions. Thanks and regards, Paul Ferguson -----Original Message----- From: Vicky Cashell Sent: Tuesday, November 27, 2001 2:16 PM To: Paul Ferguson Subject: FW: Slimline 2 -----Original Message----- From: Pierre-Alex J. Guanel [mailto:[EMAIL PROTECTED]] Sent: 26 November 2001 20:07 To: [EMAIL PROTECTED] Cc: [EMAIL PROTECTED] Subject: Slimline 2 I am using the Slimline 2 ISDN simulator from PDS technologies. I cannot get the SPID to be accepted. (See below) ISDN BRI0 interface dsl 0, interface ISDN Switchtype = basic-5ess Layer 1 Status: ACTIVE Layer 2 Status: TEI = 64, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHE TEI 64, ces = 1, state = 4(await init) spid1 configured, no LDN, spid1 sent, spid1 NOT valid I have not modifed the default phone numbers 1111 and 2222 configured on Slimline Below are my configs for bri0 interface BRI0 ip address 10.0.0.1 255.255.255.0 encapsulation ppp no ip route-cache no ip mroute-cache dialer map ip 10.0.0.2 1111 dialer-group 1 isdn switch-type basic-5ess isdn spid1 2222 Is there a default LDN number I have to configure? Pierre-Alex Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=27456&t=27456 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
