IS IOS 12.09 of cisco 2503 to configure Net3 protocol. If can , how to configure. ""Paul Ferguson"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > Hello Pierre, > > You are correct, the Simline 2 does not support SPID's but it will work > perfectly when you select the switch type on your router to NET3 which > actually emulates the basic call control of the newer ETSI Euro ISDN > network. > > The Simline 2 supports ETSI Euro ISDN and is pre-configured for the latest > numbering plan which is 'single number'. To call port 2 from port 1 you > dial 2222 for the first bearer (B) channel and then 2222 again for the > second bearer channel. If you want to dial from port 2 to port 1 you simply > dial 1111 twice. These default numbers can be changed through the Simline > software allowing any number up to 30 digits to be entered for each bearer > channel if you would like to make it more realistic. > > Once you have changed the protocol supported on your router you may wish to > monitor the signaling which can be done via the PC host used with the > Simline 2 by clicking on trace and entering a name if you wish to record > the file or clicking cancel if you just wish to look without recording. > > I hope that this helps to get you going, please do not hesitate to call or > e-mail if you have any more questions. > > Thanks and regards, > > > Paul Ferguson > > > > -----Original Message----- > From: Vicky Cashell > Sent: Tuesday, November 27, 2001 2:16 PM > To: Paul Ferguson > Subject: FW: Slimline 2 > > > -----Original Message----- > From: Pierre-Alex J. Guanel [mailto:[EMAIL PROTECTED]] > Sent: 26 November 2001 20:07 > To: [EMAIL PROTECTED] > Cc: [EMAIL PROTECTED] > Subject: Slimline 2 > > > I am using the Slimline 2 ISDN simulator from PDS technologies. > > I cannot get the SPID to be accepted. (See below) > > > ISDN BRI0 interface > dsl 0, interface ISDN Switchtype = basic-5ess > Layer 1 Status: > ACTIVE > Layer 2 Status: > TEI = 64, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHE > TEI 64, ces = 1, state = 4(await init) > spid1 configured, no LDN, spid1 sent, spid1 NOT valid > > I have not modifed the default phone numbers 1111 and 2222 configured on > Slimline > > Below are my configs for bri0 > interface BRI0 > ip address 10.0.0.1 255.255.255.0 > encapsulation ppp > no ip route-cache > no ip mroute-cache > dialer map ip 10.0.0.2 1111 > dialer-group 1 > isdn switch-type basic-5ess > isdn spid1 2222 > > Is there a default LDN number I have to configure? > > Pierre-Alex
Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=27537&t=27456 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
