You could also TFTP up and new config with the changed IP address or if you have Cisco Works or some other SNMP enabled product you could use that to change it.
-----Original Message----- From: Debbie Westall [mailto:[EMAIL PROTECTED]] Sent: Monday, December 10, 2001 8:59 AM To: [EMAIL PROTECTED] Subject: Re: how to change the serial port IP of remote end [7:28665] Rajneesh, You have two choices that I'm familiar with: 1. Using out-of-bound management, dial in to the router on the remote end and change the IP addres. Than change the host end. or 2. If you dont have a modem on the router at the remote end, telnet into the remote end of the router, change the IP addresss. You will lose connectivity to that remote immediately. Then change the IP on the host end. This is very risky, if you fat finger the IP on the remote end you will not have any connectivity at all, without power cycling the router. Good Luck Debbie Westall --- Rajneesh Yadav wrote: > Hi all, > > I want to change serial IP of my both the router one > is placed in UK.so my > question is,can i change it remotely and how its > possible.please if anyboby > can help me out. > > Regards > > Rajneesh [EMAIL PROTECTED] __________________________________________________ Do You Yahoo!? Send your FREE holiday greetings online! http://greetings.yahoo.com Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=28672&t=28665 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]