I was looking into a DS3 circuit which would be using the Point-to-Point Protocol (PPP) instead of ATM. I would then need something like a 3620 with the single port HSSI (NM-1HSSI) and some type of csu/dsu like the larscom access t45 for example. http://www.larscom.com/micro/access_t45/index.html
I am going to look into geting a ATM DS3 so that I can use the DS3/E3 ATM Network module in a 2600 which could save me some money. Thanks, Dave ----- Original Message ----- From: "MADMAN" To: "David Titov" Cc: Sent: Wednesday, December 12, 2001 11:24 AM Subject: Re: point-to-point DS3 [7:28915] > > Are you talking DS3 ATM or T3, I assuming not HSSI. Then what else > are you doing? You can get this connectivity in the form of an ATM > NM-1A-T3 (3600, 2600 series) or PA's, PA-A3-T3, PA-T3 (7200, 7500, 7100, > 7400). Look on CCO for more info on these to see if they fit your > requirements. None of these require external CSU, this is good:) > > Dave > > David Titov wrote: > > > > Does anyone have any suggestions on what type of equipment would be necessary > > for a point-to-point DS3. This would be between my corporate office and my > > Co-location facility. > > > > Router, Modules, Ram, CSU/DSU etc. > > Thanks, > > > > Dave > -- > David Madland > Sr. Network Engineer > CCIE# 2016 > Qwest Communications Int. Inc. > [EMAIL PROTECTED] > 612-664-3367 > > "Emotion should reflect reason not guide it" Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=28998&t=28915 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]