Recall that unlike access lists, if no match is found in a route map, the packet is forwarded through the normal routing process. If you look at the routing table, is the next hop for the destination 10.1.1.2?
""Dovelet"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > Hi all, > > I have a question about policy route and I hope someone can help me. The > Cisco router's config is as follow: > > : > : > interface ethernet0 > ip policy route-map route1 > ! > route-map route1 10 > match ip address 11 > match ip next-hop 12 > set ip next-hop 10.1.1.2 > ! > access-list 11 permit ip 10.2.2.1 > access-list 12 permit ip 10.1.1.1 > : > : > > In the configuration, I suppose if the packet goes into ethernet 0 with > source ip address "10.2.2.1" AND the next-hop "10.1.1.1" will match the > route-map and change its next-hop to "10.1.1.2". However, I found that the > route-map does not check the second MATCH statement (i.e. match ip next-hop > 12). I found that if the packet's source ip is "10.2.2.1" and no matter what > the next-hop ip address is, the route-map will change its next-hop to > "10.1.1.2". In the menu, it state that every MATCH statements must be > matched for the set statement to be executed. Can anyone help me? > > The router is Cisco 7200 and the IOS version is 12.0 > > Regards, > Dovelet Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=32571&t=32560 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
