Have you tried a different cable?
----- Original Message ----- From: "Craig Columbus" To: Cc: Sent: Tuesday, March 05, 2002 11:18 AM Subject: Stupid 2500 confreg question > Has anyone run into an issue where a 2500 series router won't respond to > console input? > Here's the deal: > The PC is running 9600-8-N-1 and is connected to the 2500 console port. > The router has had nvram erased and is being booted for the first time. > Upon boot, the normal boot process is seen on the monitor screen. > When prompted to enter configuration dialogue, it's not possible to input > anything on the router. Typing does nothing and there is no response from > the router. > If Ctrl-F6-Break is pressed during boot, the router goes to the > prompt, > but after that, the router still won't accept any input from the console port. > > Has anyone experienced this issue? Is this a config register problem? If > so, is there a fix other than experimenting with different settings on the > PC side? If not, does anyone have an answer? Could it be bad boot ROM? > > Thanks, > Craig > _________________________________________________________________ > Commercial lab list: http://www.groupstudy.com/list/commercial.html > Please discuss commercial lab solutions on this list. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=37284&t=37284 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]