I tried to set up default IP addressing for my dial up users on a 3640
router. I used a pool of three IP addresses for three lines. The Async group
range has Six ports, but only three have active lines.
Things were fine till the first three users connected. A strange thing was
happening after that . Users who dialed in were not getting IP addresses
from the router. This happened even when all lines were free.
On debugging PPP negotiation, I got the following error -
Se3/0 IPCP: CompressType VJ 15 slots CompressSlotID (0x0206002D0F01)
Se3/0 IPCP: Address 0.0.0.0 (0x030600000000)
Se3/0 IPCP: PrimaryDNS 0.0.0.0 (0x810600000000)
Se3/0 IPCP: PrimaryWINS 0.0.0.0 (0x820600000000)
Se3/0 IPCP: SecondaryDNS 0.0.0.0 (0x830600000000)
Se3/0 IPCP: SecondaryWINS 0.0.0.0 (0x840600000000)
Se3/0 IPCP: Using pool 'default'
Se3/0 IPCP: Cannot satisfy pool request
Se3/0 IPCP: Neither side knows remote address
On checking the IP pool when only one line was active, I got this output.
#sh ip local pool
Pool Begin End Free InUse
default 10.185.16.33 10.185.16.35 0 3
I tried using a block of 30 addresses for the pool, and things are working
fine. I had assumed that I need only three IP addresses in a pool to serve
three lines. But things are not working out that way.
Any ideas ? Any help will be greatly appreciated.
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=37525&t=37525
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
