For QoS on tunnels you must pre-classify the traffic before encryption and tunneling take place. You can do this on GRE, L2F/L2TP, and IPSec tunnels. If you are doing an Ipsec tunnel the commands you want to look at are
(config)Crypto map secured-partner-x (config-crypto-map)Qos pre-classify Sincerely, Patrick J. Greene Information Technologies Enterprises, LLC Visit our Managed Hosting Division at www.AlwaysWEB.com -----Original Message----- From: Emil [mailto:[EMAIL PROTECTED]] Sent: Thursday, March 07, 2002 4:51 AM To: [EMAIL PROTECTED] Subject: QoS fro VPN connection [7:37534] Hello, I Have a following problem. I have Cisco 1750 router with vpn ipsec tunnel to PIX ( Central Office) I want to encrypt with IPSEC traffic to Central LAN, but I want traffic destined for inerrnet goes through central PIX too, so I have to tunnel this traffic ( e.g with IPSEC AH) Now I have 2 questions: 1. AM I right, that Pix cannot route the incomming packet out to the same interface, so I need e.g. Proxy in central LAN where traffic destined for internet can go through? 2. Is that any way to set up some QoS for traffic on 1751 router going to central LAN ( give this traffic higher priority than traffic for the internet) Problem is packet going to central LAN and going to the internet via central PIX will have the same IP header (after IPSEC encryprtion) I found a feature called QoS for VPN but this is for 2600 and bigger router Thanks for any help. Emil Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=37556&t=37534 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
