I've been trying to set up RIP load balancing, and although I have two equal-cost paths, "show ip route" only shows one of the paths. When I "debug ip packets", I notice the the "len" parameter's value is different for the two serial links to the target network. The output looks like this:
IP: s=192.168.3.2 (Ethernet0), d=10.0.0.1 (Serial1), g=192.168.2.1, len 72 ... IP: s=192.168.3.2 (Ethernet0), d=10.0.0.1 (Serial1), g=192.168.1.1, len 52 ... As you can see, the "len" vlaue is different for the two paths. I should note that the target Ethernet network runs between a 2621 and a 2514. My questions are what is the "len" parameter? Is the difference in the values responsible for my inablility to load-balance? And can the len be modified? Thanks in advance for any light you can shed on this. I've searched the archives and the Cisco site, but I've been unable to find anything directly on point. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=42909&t=42909 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
