Sounds like you have old ROMs.

To run 12.x, you must have the 11.0(10c) ROMs.

The Cisco part# is BOOT-2500=

Last I checked- Cisco was offering these for free.

All the best
Phil

-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of
Sandhu Manvinder
Sent: Saturday, July 06, 2002 3:08 AM
To: [EMAIL PROTECTED]
Subject: Booting problem with Cisco 2500 [7:48226]

I have a problem with booting of 2503, It was running perfectly ok
before I
decided to upgrade its IOS to ver 12.15. As I was not aware how to do it
I
gave a command erase flash which erased the existing IOS.

Now when I boot the router I expect it to boot in the RxBoot> mode but
it
does not, it reads the ROM goes through the complete boot process and on
the
last sentence " version dated May 02 ....compiled by Kelly.." it hangs

I tried

1.      copying a flash memory with IOS loaded in the 2501 router, then
replacing
the flash chip in the 2503, it boots tells me that I have booted from
flash
but again hangs at the same position.
2.      Tried replacing the ROM chips (both of them) with 2501, but did
not work
again hangs
3.      Tried aborting the boot sequence with "Crtl break" after the
boot
sequence breaks the key board hangs..
4.      Removed the flash and the DRAM from the 2503 and tried booting,
it goes
to the netboot mode but netboot does not work since it is not configured
for
it and again hangs after reading ROM at the same position

I have not tried replacing the NVRAM, since I am not aware where this
chip
is

I don't remember if have changed any config register setting before
erasing
flash. Looking forward to your advice.

Problem number 2. This is with Cisco 2504..

It reboots after 10mins or 5 mins gives different errors. Mostly it
reads
"Bad I/O memory wrote 0x 2444933.. at  0x 33985... and read 0x 0000234."
some times it give parity error.

I have replaced Flash and DRAM but did not solve the problem, should I
try
replacing the ROM.




Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=48231&t=48226
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]

Reply via email to