Hi Gary, if you do a show interface eth 0 is there errors on the interface ?
When you have up up on the interface and no communication it is often a cable mismatch, but if you did the test with an other router ... Have you check the leds on the transiver are they the same with all routers ? Best regards -- ------------------------------------------------------------ [EMAIL PROTECTED] Computing networks & internet specialist http://www.a01faure.com Certified Cisco(ccie #8935,ccnp+cvoice), Microsoft(mcse nt4) tel./fax. 33 (0)1 45 87 95 07 PARIS(FRANCE) ------------------------------------------------------------ ""Gary Jackson"" a icrit dans le message news: [EMAIL PROTECTED] > I have a Cisco 2501 that I can not get the Ethernet 0 interface to > work. If I do a show interface, the line and line protocol are both up, I > can ping the routers address from a console session, but i can not ping the > PC that is on the same 8 port switch as the router. I have 2 other routers > that are configured almost identically...the IP address is the only > different value, that work just fine...so I don't think it is the > transceiver, or cable or switch. I don't have a smartnet on these. Can > anyone give me an idea on what Cisco might charge to repair the router > ? Or is there another place that would repair for less cost ? > > Thank you.....Gary Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=48716&t=48707 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
