Hi Group I'm setting up a new Cisco As5300 NAS . it has one 4 E1 Module and two mica 60 digital modem modules. every thing is OK but when I dial-up to it , there is not any beep from the modems . I debuged the CAS , CSM on it , but I can't find the Problem
00:53:07: from Trunk(0): (0/8): Rx SEIZURE (ABCD=0001) 00:53:08: VDEV_ALLOCATE: 2/1 is allocated 00:53:08: 3.dsx0 call reset dnis_collected & fap_notify 00:53:08: CSM_RX_CAS_EVENT_FROM_NEAT:(cid0008): EVENT_CALL_DIAL_IN at slot 2 and port 1 00:53:08: CSM_PROC_IDLE: CSM_EVENT_DSX0_CALL at slot 2, port 1 00:53:08: Mica Modem(2/1): Configure(0x1 = 0x0) 00:53:08: Mica Modem(2/1): Configure(0x23 = 0x2) 00:53:08: Mica Modem(2/1): Call Setup 00:53:08: csm_connect_pri_vdev: TS allocated at bp_stream 0, bp_Ch 7, vdev_common 0x61B93DC8 2/1 00:53:08: to NEAT:(cid0008) EVENT_CHANNEL_LOCK for slot0 ctlr0 chan8 00:53:08: Mica Modem(2/1): State Transition to Call Setup RM-NAS# 00:53:08: Mica Modem(2/1): Went offhook 00:53:08: CSM_PROC_IC2_RING: CSM_EVENT_MODEM_OFFHOOK at slot 2, port 1 00:53:08: cas_group=1, service=2 00:53:08: csm_res_response: service_type=0, fax_call=0, fap_notify=0 00:53:08: CSM_PROC_IC3_WAIT_FOR_RES_RESP: CSM_EVENT_RESOURCE_OK at slot 2, port 1 00:53:08: CSM_RX_CAS_EVENT_FROM_NEAT:(0008): EVENT_START_RX_TONE at slot 2 and port 1 00:53:08: from Trunk(0): (0/8): Tx SEIZURE_ACK (ABCD=1101) 00:53:08: CSM_RX_CAS_EVENT_FROM_NEAT:(0008): EVENT_CHANNEL_CONNECTED at slot 2 and port 1 00:53:08: CSM_PROC_IC6_WAIT_FOR_CONNECT: CSM_EVENT_DSX0_CONNECTED at slot 2, port 1 00:53:08: Mica Modem(2/1): Link Initiate 00:53:08: from Trunk(0): (0/8): Tx ANSWERED (ABCD=0101) 00:53:09: Mica Modem(2/1): State Transition to Connect 00:53:13: from Trunk(0): (0/8): Rx IDLE (ABCD=1001) 00:53:14: Mica Modem(2/1): State Transition to Link RM-NAS# RM-NAS# RM-NAS# RM-NAS# 00:53:15: from Trunk(0): (0/8): Tx IDLE (ABCD=1001) 00:53:15: CSM_RX_CAS_EVENT_FROM_NEAT:(0008): EVENT_CALL_IDLE at slot 2 port 1 cause 200 00:53:15: CSM_PROC_IC7_OC6_CONNECTED: CSM_EVENT_DSX0_DISCONNECTED at slot 2, port 1 00:53:15: Mica Modem(2/1): Link Terminate(0x6) 00:53:15: CSM(2/1): Enter csm_enter_disconnecting_state 00:53:15: VDEV_DEALLOCATE: slot 2 and port 1 is deallocated 00:53:15: Mica Modem(2/1): State Transition to Terminating 00:53:15: Mica Modem(2/1): State Transition to Idle 00:53:15: Mica Modem(2/1): Went onhook 00:53:15: CSM_PROC_IC8_OC8_DISCONNECTING: CSM_EVENT_MODEM_ONHOOK at slot 2, port 1 00:53:15: CSM(2/1): Enter csm_enter_idle_state 00:53:15: from Trunk(0): (0/9): Rx SEIZURE (ABCD=0001) 00:53:15: VDEV_ALLOCATE: 2/2 is allocated 00:53:15: 3.dsx0 call reset dnis_collected & fap_notify 00:53:15: CSM_RX_CAS_EVENT_FROM_NEAT:(cid0009): EVENT_CALL_DIAL_IN at slot 2 and port 2 00:53:15: CSM_PROC_IDLE: CSM_EVENT_DSX0_CALL at slot 2, port 2 00:53:15: Mica Modem(2/2): Configure(0x1 = 0x0) 00:53:15: Mica Modem(2/2): Configure(0x23 = 0x2) 00:53:15: Mica Modem(2/2): Call Setup 00:53:15: csm_connect_pri_vdev: TS allocated at bp_stream 0, bp_Ch 8, vdev_common 0x61B95A30 2/2 00:53:15: to NEAT:(cid0009) EVENT_CHANNEL_LOCK for slot0 ctlr0 chan9 00:53:16: Mica Modem(2/2): State Transition to Call Setup 00:53:16: Mica Modem(2/2): Went offhook 00:53:16: CSM_PROC_IC2_RING: CSM_EVENT_MODEM_OFFHOOK at slot 2, port 2 00:53:16: cas_group=1, service=2 00:53:16: csm_res_response: service_type=0, fax_call=0, fap_notify=0 00:53:16: CSM_PROC_IC3_WAIT_FOR_RES_RESP: CSM_EVENT_RESOURCE_OK at slot 2, port 2 00:53:16: CSM_RX_CAS_EVENT_FROM_NEAT:(0009): EVENT_START_RX_TONE at slot 2 and port 2 00:53:16: from Trunk(0): (0/9): Tx SEIZURE_ACK (ABCD=1101) 00:53:16: CSM_RX_CAS_EVENT_FROM_NEAT:(0009): EVENT_CHANNEL_CONNECTED at slot 2 and port 2 00:53:16: CSM_PROC_IC6_WAIT_FOR_CONNECT: CSM_EVENT_DSX0_CONNECTED at slot 2, port 2 00:53:16: Mica Modem(2/2): Link Initiate 00:53:16: from Trunk(0): (0/9): Tx ANSWERED (ABCD=0101) 00:53:17: Mica Modem(2/2): State Transition to Connect 00:53:22: Mica Modem(2/2): State Transition to Link 00:53:26: Mica Modem(2/2): State Transition to Trainup 00:53:34: Mica Modem(2/2): State Transition to Terminating 00:53:34: Mica Modem(2/2): State Transition to Idle 00:53:34: Mica Modem(2/2): Went onhook 00:53:34: CSM_PROC_IC7_OC6_CONNECTED: CSM_EVENT_MODEM_ONHOOK at slot 2, port 2 00:53:34: CSM(2/2): Enter csm_enter_idle_state 00:53:34: VDEV_DEALLOCATE: slot 2 and port 2 is deallocated 00:53:34: from Trunk(0): (0/9): Tx BWD_CLEAR (ABCD=1101) 00:53:41: from Trunk(0): (0/9): Rx IDLE (ABCD=1001) 00:53:43: from Trunk(0): (0/9): Tx IDLE (ABCD=1001) here is my running config : spe 1/0 2/9 firmware location flash:mica-modem-pw.2.9.2.0.bin ! controller E1 0 framing NO-CRC4 clock source line secondary 1 ds0-group 1 timeslots 1-15,17-31 type r2-digital cas-custom 1 description E1 Demodulator 1 ! controller E1 1 framing NO-CRC4 ds0-group 1 timeslots 1-15,17-31 type r2-digital cas-custom 1 ! controller E1 2 framing NO-CRC4 ds0-group 1 timeslots 1-15,17-31 type r2-digital cas-custom 1 ! controller E1 3 framing NO-CRC4 ds0-group 1 timeslots 1-15,17-31 type r2-digital cas-custom 1 ! interface Group-Async1 description Digital-Modem Module in BAY 2 ip unnumbered Loopback1 encapsulation ppp ip tcp header-compression async default routing async mode dedicated peer default ip address pool Valid ppp quality 70 ppp authentication pap ms-chap dial-in ppp accounting ppp-acct group-range 1 120 ! line 1 120 no flush-at-activation login authentication dial-in modem Dialin modem autoconfigure type mica transport input all autoselect ppp Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=49010&t=49010 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
