The Micas don't beep. Dave
Reza wrote: > > Hi Group > I'm setting up a new Cisco As5300 NAS . > it has one 4 E1 Module and two mica 60 digital modem modules. > every thing is OK but when I dial-up to it , there is not any beep from the > modems . > I debuged the CAS , CSM on it , but I can't find the Problem > > 00:53:07: from Trunk(0): (0/8): Rx SEIZURE (ABCD=0001) > 00:53:08: VDEV_ALLOCATE: 2/1 is allocated > 00:53:08: 3.dsx0 call reset dnis_collected & fap_notify > 00:53:08: CSM_RX_CAS_EVENT_FROM_NEAT:(cid0008): EVENT_CALL_DIAL_IN at slot 2 > and port 1 > 00:53:08: CSM_PROC_IDLE: CSM_EVENT_DSX0_CALL at slot 2, port 1 > 00:53:08: Mica Modem(2/1): Configure(0x1 = 0x0) > 00:53:08: Mica Modem(2/1): Configure(0x23 = 0x2) > 00:53:08: Mica Modem(2/1): Call Setup > 00:53:08: csm_connect_pri_vdev: TS allocated at bp_stream 0, bp_Ch 7, > vdev_common 0x61B93DC8 2/1 > 00:53:08: to NEAT:(cid0008) EVENT_CHANNEL_LOCK for slot0 ctlr0 chan8 > 00:53:08: Mica Modem(2/1): State Transition to Call Setup > RM-NAS# > 00:53:08: Mica Modem(2/1): Went offhook > 00:53:08: CSM_PROC_IC2_RING: CSM_EVENT_MODEM_OFFHOOK at slot 2, port 1 > 00:53:08: cas_group=1, service=2 > 00:53:08: csm_res_response: service_type=0, fax_call=0, fap_notify=0 > 00:53:08: CSM_PROC_IC3_WAIT_FOR_RES_RESP: CSM_EVENT_RESOURCE_OK at slot 2, > port 1 > 00:53:08: CSM_RX_CAS_EVENT_FROM_NEAT:(0008): EVENT_START_RX_TONE at slot 2 > and port 1 > 00:53:08: from Trunk(0): (0/8): Tx SEIZURE_ACK (ABCD=1101) > 00:53:08: CSM_RX_CAS_EVENT_FROM_NEAT:(0008): EVENT_CHANNEL_CONNECTED at > slot 2 and port 1 > 00:53:08: CSM_PROC_IC6_WAIT_FOR_CONNECT: CSM_EVENT_DSX0_CONNECTED at slot 2, > port 1 > 00:53:08: Mica Modem(2/1): Link Initiate > 00:53:08: from Trunk(0): (0/8): Tx ANSWERED (ABCD=0101) > 00:53:09: Mica Modem(2/1): State Transition to Connect > 00:53:13: from Trunk(0): (0/8): Rx IDLE (ABCD=1001) > 00:53:14: Mica Modem(2/1): State Transition to Link > RM-NAS# > RM-NAS# > RM-NAS# > RM-NAS# > 00:53:15: from Trunk(0): (0/8): Tx IDLE (ABCD=1001) > 00:53:15: CSM_RX_CAS_EVENT_FROM_NEAT:(0008): EVENT_CALL_IDLE at slot 2 port > 1 cause 200 > 00:53:15: CSM_PROC_IC7_OC6_CONNECTED: CSM_EVENT_DSX0_DISCONNECTED at slot 2, > port 1 > 00:53:15: Mica Modem(2/1): Link Terminate(0x6) > 00:53:15: CSM(2/1): Enter csm_enter_disconnecting_state > 00:53:15: VDEV_DEALLOCATE: slot 2 and port 1 is deallocated > > 00:53:15: Mica Modem(2/1): State Transition to Terminating > 00:53:15: Mica Modem(2/1): State Transition to Idle > 00:53:15: Mica Modem(2/1): Went onhook > 00:53:15: CSM_PROC_IC8_OC8_DISCONNECTING: CSM_EVENT_MODEM_ONHOOK at slot 2, > port 1 > 00:53:15: CSM(2/1): Enter csm_enter_idle_state > 00:53:15: from Trunk(0): (0/9): Rx SEIZURE (ABCD=0001) > 00:53:15: VDEV_ALLOCATE: 2/2 is allocated > 00:53:15: 3.dsx0 call reset dnis_collected & fap_notify > 00:53:15: CSM_RX_CAS_EVENT_FROM_NEAT:(cid0009): EVENT_CALL_DIAL_IN at slot 2 > and port 2 > 00:53:15: CSM_PROC_IDLE: CSM_EVENT_DSX0_CALL at slot 2, port 2 > 00:53:15: Mica Modem(2/2): Configure(0x1 = 0x0) > 00:53:15: Mica Modem(2/2): Configure(0x23 = 0x2) > 00:53:15: Mica Modem(2/2): Call Setup > 00:53:15: csm_connect_pri_vdev: TS allocated at bp_stream 0, bp_Ch 8, > vdev_common 0x61B95A30 2/2 > 00:53:15: to NEAT:(cid0009) EVENT_CHANNEL_LOCK for slot0 ctlr0 chan9 > 00:53:16: Mica Modem(2/2): State Transition to Call Setup > 00:53:16: Mica Modem(2/2): Went offhook > 00:53:16: CSM_PROC_IC2_RING: CSM_EVENT_MODEM_OFFHOOK at slot 2, port 2 > 00:53:16: cas_group=1, service=2 > 00:53:16: csm_res_response: service_type=0, fax_call=0, fap_notify=0 > 00:53:16: CSM_PROC_IC3_WAIT_FOR_RES_RESP: CSM_EVENT_RESOURCE_OK at slot 2, > port 2 > 00:53:16: CSM_RX_CAS_EVENT_FROM_NEAT:(0009): EVENT_START_RX_TONE at slot 2 > and port 2 > 00:53:16: from Trunk(0): (0/9): Tx SEIZURE_ACK (ABCD=1101) > 00:53:16: CSM_RX_CAS_EVENT_FROM_NEAT:(0009): EVENT_CHANNEL_CONNECTED at > slot 2 and port 2 > 00:53:16: CSM_PROC_IC6_WAIT_FOR_CONNECT: CSM_EVENT_DSX0_CONNECTED at slot 2, > port 2 > 00:53:16: Mica Modem(2/2): Link Initiate > 00:53:16: from Trunk(0): (0/9): Tx ANSWERED (ABCD=0101) > 00:53:17: Mica Modem(2/2): State Transition to Connect > 00:53:22: Mica Modem(2/2): State Transition to Link > 00:53:26: Mica Modem(2/2): State Transition to Trainup > 00:53:34: Mica Modem(2/2): State Transition to Terminating > 00:53:34: Mica Modem(2/2): State Transition to Idle > 00:53:34: Mica Modem(2/2): Went onhook > 00:53:34: CSM_PROC_IC7_OC6_CONNECTED: CSM_EVENT_MODEM_ONHOOK at slot 2, port > 2 > 00:53:34: CSM(2/2): Enter csm_enter_idle_state > 00:53:34: VDEV_DEALLOCATE: slot 2 and port 2 is deallocated > > 00:53:34: from Trunk(0): (0/9): Tx BWD_CLEAR (ABCD=1101) > 00:53:41: from Trunk(0): (0/9): Rx IDLE (ABCD=1001) > 00:53:43: from Trunk(0): (0/9): Tx IDLE (ABCD=1001) > > here is my running config : > > spe 1/0 2/9 > firmware location flash:mica-modem-pw.2.9.2.0.bin > ! > controller E1 0 > framing NO-CRC4 > clock source line secondary 1 > ds0-group 1 timeslots 1-15,17-31 type r2-digital > cas-custom 1 > description E1 Demodulator 1 > ! > controller E1 1 > framing NO-CRC4 > ds0-group 1 timeslots 1-15,17-31 type r2-digital > cas-custom 1 > ! > controller E1 2 > framing NO-CRC4 > ds0-group 1 timeslots 1-15,17-31 type r2-digital > cas-custom 1 > ! > controller E1 3 > framing NO-CRC4 > ds0-group 1 timeslots 1-15,17-31 type r2-digital > cas-custom 1 > ! > > interface Group-Async1 > description Digital-Modem Module in BAY 2 > ip unnumbered Loopback1 > encapsulation ppp > ip tcp header-compression > async default routing > async mode dedicated > peer default ip address pool Valid > ppp quality 70 > ppp authentication pap ms-chap dial-in > ppp accounting ppp-acct > group-range 1 120 > ! > line 1 120 > no flush-at-activation > login authentication dial-in > modem Dialin > modem autoconfigure type mica > transport input all > autoselect ppp -- David Madland Sr. Network Engineer CCIE# 2016 Qwest Communications Int. Inc. [EMAIL PROTECTED] 612-664-3367 "Emotion should reflect reason not guide it" Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=49021&t=49010 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]