Mark,
Your diagram is correct. I am trying to load balance/share across the
links to the PER (per-packet preferably). The clients are behind Rtr A & B
using an HSRP address. So say Rtr A is the active router. I want to load
balance across both links (half of the traffic needs to traverse out Rtr A's
ser0 and the other half across the link to Rtr B and then out it's ser0). If
I use a static and one link goes down, half of my traffic becomes
blackholed. I was trying to find a way to have a default route put into a
routing protocol so the routing process would recognize that if one link was
down that it needed to send all traffic out the remaining link. Is this
clearer?
Turpin, Mark wrote:
>
> Jason,
>
> Is this your lab network?
>
> ++++++++++++
> + PE Rtr +
> ++++++++++++
> / \
> / \
> ++++++++ +++++++++
> + RtrA +----------+ Rtr B +
> ++++++++ +++++++++
> \-> Client Networks
> With that diagram, or a revised one, can you clarify
> your question? You mention statics; what routers are
> you trying to advertise statics to, and from what router
> are you wishing to advertise them?
>
> In regards to load balancing, are you asking if you
> can load balance clients to router A and router B?
> Or do you want to load balance the PE router to A&B?
>
> Thanks,
> -Mark
>
>
> -----Original Message-----
> From: Jason Owens [mailto:[EMAIL PROTECTED]]
> Sent: Thursday, August 08, 2002 4:16 PM
> To: [EMAIL PROTECTED]
> Subject: load balance/share [7:50988]
>
>
> I am trying to lab up a scenario where I can load balance/share
> across two
> routers (for redundancy) connected into an MPLS cloud.
> Additionally, I have
> HSRP running between the two (I don't want to use MHSRP because
> I don't want
> two gateways on the LAN). There is a direct connection between
> the routers.
>
> I know I can use statics, however I want all traffic to be able
> to failover
> to the remaining link if one goes down, instead of being being
> blackholed.
>
> | |
> | |
> Router 1-------Router 2
> active standby
>
> I have tried with EIGRP, however I was having trouble with
> getting a default
> route injected in (without using statics). Is there any way to
> do this?
> "The information transmitted is intended only for the person
> or entity to
> which it is addressed and may contain confidential and/or
> privileged
> material. Any review, retransmission, dissemination or other
> use of, or
> taking of any action in reliance upon, this information by
> persons or
> entities other than the intended recipient is prohibited. If
> you received
> this in error, please contact the sender and delete the
> material from all
> computers."
>
>
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=51060&t=50988
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
